![eurotherm itools add wire eurotherm itools add wire](https://capitaine-az.com/cheltt/kra4ZNCWQj9tLvjQ2XxBSgHaEH.jpg)
The positive (+) pole of the used N-type thermocouple (pink wire) must be connected to the shorter pin and the negative (-) (white wire) to the longer pin of the thermocouple feedthrough on the manipulator. Operation Warning! Do not connect the thermocouple input during e-beam annealing with applied high voltage.Īfter the switch-on procedure, the controller can be operated manually from the PID module by buttons 1a-e, or remotely from PC (see Software section). When PID is disconnected, place the blank J3 connector. Wire connections from PID to Elind rear side Use only one type of input.Ĭonnector for a programmable logical input of the PID controller.
EUROTHERM ITOOLS ADD WIRE MANUAL
As of 2016, switch 6 can switch on the full level of manual operation switch 7 is idle.
![eurotherm itools add wire eurotherm itools add wire](https://img.directindustry.com/pdf/repository_di/14491/itools-874503_1mg.jpg)
Rocker switches to switch on/off some of the programmable functions of the Eurotherm PID controller. Switch to select the manual or remote control of the Sorensen voltage or current output. When the switch 3 is in the current position, the potentiometer set the voltage output limit (1 turn = 7.5V). When the switch 3 is in voltage position, the potentiometer sets the current output limit (1 turn = 3.6 A). Rotary switch to select the remote control of Elind voltage or current output.Ī 10-turn potentiometer to set Elind output limit. Rocker switch to select the remote control of Elind or Sorensen power supply. Lower readout (output level in Manual mode temperature setpoint in Auto mode). Upper readout showing measured temperature (Sbr = Sensor break). Block diagram of PID controlled heating system at Endstation A of the BACH beamline.Įurotherm 2408 PID controller with one analog output 0-10 Vdc. The temperature controller box is designed to remotely control Elind () or Sorensen (Model DCS-100-12E) power supplies at BACH beamline, which are used for heaters in the experimental chambers of the Endstation A.Ĭonnections between the controller and other appliances are schematically depicted in Scheme 1.